Instruction manual

3-15
BIOS Setup
when you disable the function, but system will need
an AGP driver to initialize the VGA card. Therefore,
if the AGP driver of the card does not support the
initialization feature, the display may work
abnormally or not function after resuming from S3.
Options: [Auto], [Yes], [No].
Suspend Time Out (Minute)
If system activity is not detected for the length of time specified in this field, all
devices except CPU will be shut off. Settings: [Disabled], [1], [2], [4], [8], [10], [20],
[30], [40], [50], [60].
Power Button Function
This feature allows users to configure the Power Button function. Settings are:
[Power Off] The power button functions as a normal power-on/-off button.
[Suspend] When you press the power button, the computer enters the
suspend/sleep mode, but if the button is pressed for more
than four seconds, the computer is turned off.
Restore on AC/Power Loss
This setting specifies whether your system will reboot after a power failure or
interrupt occurs. Available settings are:
[Off] Leaves the computer in the power off state.
[On] Leaves the computer in the power on state.
[Last State] Restores the system to the previous status before power
failure or interrupt occurred.
Wakeup Event Setup
Press <Enter> and the following sub-menu appears.
Resume From S3 by USB Device
The item allows the activity of the USB device to
wake up the system from S3 (Suspend to RAM) sleep
state. Setting options: [Disabled], [Enabled].
Resume by PCI/PCI-E Device
This controls how and whether the system can be powered on by the devices
installed on PCI/PCI-E slots. Setting options: [Disabled], [Enabled].
Resume On RTC Alarm
This is used to enable or disable the feature of booting up the system on a scheduled
time/date from the S3, S4, and S5 power off state. Setting options: [Disabled], [Enabled].
Date/Time (HH:MM:SS)
If Resume By RTC Alarm is set to [Enabled], the system will automatically resume
(boot up) on a specific date/hour/minute/second specified in these fields (using the
<+> and <-> to select the date & time settings). Available settings for each item are:
Date 01 ~ 31, Every Day
Time (HH:MM:SS) 00 ~ 23 : 00 ~ 59 : 00 ~ 59