Instruction manual

2-13
Hardware Setup
The mainboard provides connectors to connect to FDD, IDE HDD, case, LAN,
and USB Ports.
Floppy Disk Drive Connector: FDD1
The mainboard provides a standard floppy disk drive connector that supports
360K, 720K, 1.2M, 1.44M and 2.88M floppy disk types.
Connectors
FDD1 (Black)
Fan Power Connectors: CPU_FAN1/ SYS_FAN1
The CPU_FAN1(processor fan) and SYS_FAN1 (system fan) support system
cooling fan with +12V. It supports four/three-pin head connector. When connecting
the wire to the connectors, always take note that the red wire is the positive and
should be connected to the +12V, the black wire is Ground and should be connected
to GND. If the mainboard has a System Hardware Monitor chipset on-board, you must
use a specially designed fan with speed sensor to take advantage of the CPU fan
control.
SYS_FAN1
CPU_FAN1
SENSOR
+12V
GND
Control
MSI Reminds You...
1.Always consult the vendors for proper CPU cooling fan.
2.CPU_FAN1 supports the fan control. Fan/heatsink with 3 or 4 fins
are both available.
3.Please refer to the recommended CPU fans at Intel
®
official
website.
Sensor
+12V
GND