User`s manual
2-13
Hardware Setup
Connectors
Floppy Disk Drive Connector: FDD1
This connector supports 360KB, 720KB, 1.2MB, 1.44MB or 2.88MB floppy disk drive.
IDE Connector: IDE1, IDE2
This connector supports IDE hard disk drives, optical disk drives and other IDE devices.
Important
If you install two IDE devices on the same cable, you must configure the
drives separately to master / slave mode by setting jumpers. Refer to IDE
deviceβs documentation supplied by the vendors for jumper setting
instructions.
IDE1
by nForce 570i SLI
FDD1
IDE2
by JMB363
7510v1.0_2_Hardware.p65 2008/1/7, δΈε 02:4413