User`s manual

3-21
BIOS Setup
tWTR
When the Memory Timings is set to [Manual], the field is adjustable. This item
controls the Write Data In to Read Command Delay memory timing. This consti-
tutes the minimum number of clock cycles that must occur between the last
valid write operation and the next read command to the same internal bank of
the DDR device.
tREF
When the Memory Timings is set to [Manual], the field is adjustable. Speci-
fies the refresh rate of the DIMM requiring the most frequent refresh.
1T/2T Memory Timing
When the Memory Timings is set to [Manual], the field is adjustable. This field
controls the SDRAM command rate. Selecting [1T] makes SDRAM signal con-
troller to run at 1T (T=clock cycles) rate. Selecting [2T] makes SDRAM signal
controller run at 2T rate.
Adjust PCI-E Frequency
This field allows you to select the PCIE frequency (in MHz).
Auto Disabled DRAM/PCI Frequency
When set to [Enabled], the system will remove (turn off) clocks from empty DIMM and
PCI slots to minimize the electromagnetic interference (EMI).
CPU Voltage (V)
This item allows you to increase the CPU voltage.
DRAM Voltage (V)
Adjusting the voltage can increase the memory speed.
NB Voltage (V)
Adjust the North Bridge chipset voltage.
SB Voltage (V)
Adjust the South Bridge voltage.
NB Memory Reference Voltage
This item allows you to set the NB Memory Reference voltage.
Memory Reference Voltage
This item allows you to set the Memory Reference voltage.
Memory Terminator Voltage
This item allows you to set the Memory Terminator voltage.
CPU GTL Reference Voltage
This item allows you to set the CPU GTL Reference voltage.
7510v1.0-3_ami.p65 2008/1/7, 下午 02:4421