User`s manual

B-7
nVidia RAID
Installing Driver
Install Driver in Windows Vista / XP
† New Windows Vista / XP Installation
The following details the installation of the drivers while installing Windows XP /
2000.
1. When you start installing Windows XP and older operating systems, you may
encounter a message stating, “Setup could not determine the type of one or
more mass storage devices installed in your system”. If this is the case, then
you are already in the right place and are ready to supply the driver. If this is
not the case, then press F6 when prompted at the beginning of Windows
setup.
2. Press the “S” key to select “Specify Additional Device”.
3. You should be prompted to insert a floppy disk containing the NVIDIA RAID
driver into the A: drive,and then press ENTER.
Important
Please follow the instruction below to make an “NVIDIA RAID Driver” for
yourself.
1. Insert the MSI CD into the CD-ROM drive.
2. Click the “Browse CD” on the Setup screen.
3.Copy all the contents in the
\\Chipset\nVidia\System\C72+MCP55\IDE\WinXP\Sataraid to a formatted
floppy disk.
4.The driver diskette for NVIDIA RAID Controller is done.
4. You should be shown a list of available NVRAID Adapters.
5. Select the “NVIDIA RAID Driver” and press ENTER.
6. Press “S” again at the Specify Devices screen, then press ENTER.
7. Select “NVIDIA nforce Storage Controller” and then press ENTER. The follow-
ing Windows Setup screen appears listing both drivers:
For Windows Vista:
8. During the Operating system installation, after selecting the location to install
Vista click on “Load Driver” button to install a RAID driver.
9. When prompted, insert the floppy disk or media (Floppy, CD/DVD or USB) you
created in step 3 and press Enter.
10.You should be shown a list of available NVRAID controllers.
11.Select the “NVIDIA nforce RAID Controller” and press ENTER.
7510v1.0-B_NVRAID.p65 2008/1/7, 下午 02:447