Instruction manual

2-21
System Hardware
Cable Arm (Optional)
An optional cable arm is available to help
tidy the system cables up.
The cable arm attaches to the rear of the
server and the system rack, allowing cables
to move as the server slides back and forth
within the rack cabinet.
1. First screw the right rack rail to the
rack. Go check the right rail on the rear
(virtually the left rail if viewed from the rear
of the cabinet) and you’ll find the cable arm
holder at the end of the rail. Insert the clip
(the narrow end) of the cable arm into the
cable arm holder and push it forwards until
you hear a ‘clip’ sound.
2. At the other end of the cable arm are
two holes. Align the holes of the cable arm
with the tabs on the rack rail (as indicated
by circles and arrows).
3. Fit the tabs into the holes.