User Manual

Hardware Setup ▍
MS-96D2
2-11
Hardware Setup ▍
MS-96D2
connectorS
Fan Power Connector: CPU_FAN1 / SYS_FAN1~3
The fan power connectors support system cooling fan with +12V. When con-
necting the wire to the connectors, always note that the red wire is the positive
and should be connected to the +12V; the black wire is Ground and should be
connected to GND. If the mainboard has a System Hardware Monitor chipset
on-board, you must use a specially designed fan with speed sensor to take ad-
vantage of the CPU fan control.
Important
Please refer to the recommended CPU fans at processor’s ofcial website or
consult the vendors for proper CPU cooling fan.
Serial Port Connector: JCOM2
This connector is a 16550A high speed communications port that sends/receives
16 bytes FIFOs. You can attach a serial device to it.
PIN SIGNAL
1
2
3
4
GND
+12V
Sensor
Control
1
4
PIN SIGNAL DESCRIPTION
1
2
3
4
5
6
7
8
9
DCD
SIN
SOUT
DTR
GND
DSR
RTS
CTS
RI
Data Carry Detect
Serial In or Receive Data
Ser
ial Out or Transmit Data
Data Terminal Ready
Ground
Data Set Ready
Request To Send
Clear To Send
R
ing Indicate
1
2
9
10