Owner's Manual

Hardware Setup ▍
MS-96E0
2-7
Hardware Setup ▍
MS-96E0
Installing Memory Modules
The memory module has only one notch on the center and will only t in the
right orientation.
Insert the memory module vertically into the DIMM slot. Then push it in until
the golden nger on the memory module is deeply inserted in the DIMM slot.
The plastic clip at each side of the DIMM slot will automatically close when
the memory module is properly seated.
Manually check if the memory module has been locked in place by the DIMM
slot clips at the sides.
Important
You can barely see the golden nger if the memory module is properly inserted
in the DIMM slot.
Notch
Volt
Important
In Multi-Channel mode, make sure that you install memory modules of the
same type and density in different channel DIMM slots.
To enable successful system boot-up, always insert the memory modules into
the DIMM1 rst.
1.
2.
3.
•
•