Owner's Manual
Hardware Setup
▍
MS-96E0
2-11
Hardware Setup
▍
MS-96E0
IDE Connector: JIDE1
This connector supports IDE hard disk drives, optical disk drives and other IDE
devices.
Important
If you install two IDE devices on the same cable, you must congure the drives
separately to master / slave mode by setting jumpers. Refer to IDE device’s docu-
mentation supplied by the vendors for jumper setting instructions.
Fan Power Connector: CPU0_FAN, CPU1_FAN, SYS_FAN1/2/3/4
The fan power connectors support system cooling fan with +12V. When con-
necting the wire to the connectors, always note that the red wire is the positive
and should be connected to the +12V; the black wire is Ground and should be
connected to GND. If the mainboard has a System Hardware Monitor chipset
onboard, you must use a specially designed fan with speed sensor to take ad-
vantage of the CPU fan control.
Important
Please refer to the recommended CPU fans at processor’s ofcial website or
consult the vendors for proper CPU cooling fan.
PIN SIGNAL
1
2
3
4
GND
+12V
Sensor
Control
14