Owner's Manual

2-14
Hardware Setup ▍
MS-96E0
Hardware Setup ▍
MS-96E0
Chassis Intrusion Switch Connector: INTRUDER
This connector connects to the chassis intrusion switch cable. If the chassis is
opened, the chassis intrusion mechanism will be activated. The system will re-
cord this status and show a warning message on the screen. To clear the warn-
ing, you must enter the BIOS utility and clear the record.
I2C Bus Connector: JSMBUS2
This connector, known as I2C, is for users to connect System Management Bus
(SMBus) interface.
SPI Flash ROM Connector: J2
This connector is used to ash SPI ash ROM.
PIN SIGNAL PIN SIGNAL
1
3
5
7
9
+3.3V DUAL
SPI_MISO
SPI_CS0#_R
GND
SPI_HOLD#
2
4
6
8
10
+3.3V DUAL
SPI_MOSI_R
SPI_CLK_R
GND
NC
2
1
10
9
CINTRU
GND
PIN SIGNAL
1
2
3
4
5
SMB_PWR_5VDUAL_CLK
SMB_PWR_5VDUAL_DAT
IRQ_SMB_PWR_ALERT_N
GND
+3.3V
1 5
IPMB Connector: JIPMB1
This connector is used to connect the IPMB (Intelligent Platform Management
Bus) SMBus.
PIN SIGNAL
1
2
3
SMB_IPMB_5VSB_DAT
GND
SMB_IPMB_5VSB_CLK
1