Owner's Manual

A-10

Intel ICH10R SATA RAID

▍

MS-96E0

Intel ICH10R SATA RAID

▍

MS-96E0

inStaLLinG driver

Important

Please follow the instruction below to make an “Intel

RAID Driver” for yourself.

Insert the MSI CD into the CD-ROM drive.

Click the “Browse CD” on the Setup screen.

Copy all the contents in \\SATA2_RAID\f6py3288 (32 bits) or \\SATA2_

RAID\f6py6488 (64 bits) to a formatted disk.

The driver disk for Intel

ICH10R RAID Controller is done.

Install Driver in Windows Server 2008/2003

The following details the installation of the drivers while installing operating sys-

tem.

When you start installing Windows Server 2008/2003, you may encounter a

message stating, etup could not determine the type of one or more mass stor-

age devices installed in your system? If this is the case, then you are already

in the right place and are ready to supply the driver. For Windows 2003, if this

is not the case, then press F6 when prompted at the beginning of Windows

setup.

Press the “S” key to select “Specify Additional Device”.

You should be prompted to insert a disk containing the Intel

RAID driver.

■

During the Operating system installation, after selecting the location to install,

click on “Load Driver” button to install a third party SCSI or RAID driver.

When prompted, insert the disk (CD/DVD or USB) you created in step 3 and

press Enter.

You should be shown a list of available SCSI Adapters.

Select the appropriate Intel RAID controller and press ENTER.

The next screen should conrm that you have selected the Intel

RAID control-

ler. Press ENTER again to continue.

You have successfully installed the Intel

SATA RAID driver, and Windows

setup should continue.

Leave the disk in the drive until the system reboots itself. Windows setup will

need to copy the les from the disk again after the RAID volume is formatted,

and Windows setup starts copying les.

10.