Manualshelf

Owner's Manual

ManualsBrandsMSI ManualsComputer equipmentMS-96E3
21222324252627282930
2-14
Hardware Setup
MS-96E3
Hardware Setup
MS-96E3
connector
Serial ATA Connector: SATA0 ~ SATA3
This connector is a high-speed Serial ATA interface port. Each connector can
connect to one Serial ATA device.
Important
Please do not fold the SATA cable into 90-degree angle. Otherwise, data loss
may occur during transmission.
IDE Connector: IDE1
This connector supports IDE hard disk drives, optical disk drives and other IDE
devices.
Important
If you install two IDE devices on the same cable, you must congure the drives
separately to master / slave mode by setting jumpers. Refer to IDE device’s docu-
mentation supplied by the vendors for jumper setting instructions.