Specifications

164 IBM Flex System p260 and p460 Planning and Implementation Guide
If a DHCP response is not received within 3 minutes of the CMM Ethernet port
being connected to the network, the CMM uses the factory default IP address
and subnet mask. During this 3-minute interval, the CMM is not accessible.
The CMM has the following default settings:
򐂰 IP address: 192.168.70.100
򐂰 Subnet: 255.255.255.0
򐂰 User ID: USERID (all capital letters)
򐂰 Password: PASSW0RD (all capital letters, with a zero instead of the letter O)
The default information, MAC address, and IPv6 link-local address is available in
the network access card attached to all new CMMs, as shown in Figure 6-5.
Figure 6-5 Chassis Management Module network access tag
Initial configuration of the Chassis Management Module
The CMM is accessible by using a browser and either the DHCP-obtained
address or the default IP settings. The default security setting is
secure, so
HTTPS is required to connect to the CMM.
Network
access tag
C
o
n
n
e
c
t
v
i
a
S
ta
t
ic
I
P