Specifications

Chapter 6. Management setup 203
To initiate an IMMv2 remote console session, complete the following steps:
1. Start a browser session, as shown in Figure 6-42, to the IP address of the
FSM IMMv2.
Figure 6-42 IMMv2 login
Important: The IP address of the IMMv2 of Intel compute nodes can be
determined by using the Chassis Management Module or CLI. By default,
the interface is set to use DHCP. You can change this setting to a static
address using the CMM, a CLI, or a console connected directly to the VGA
port on the front of the FSM (accessible with the use of the console
breakout cable).