Specifications

240 IBM Flex System p260 and p460 Planning and Implementation Guide
Figure 6-89 shows the next window, which steps you through the process.
Notice that the User ID box is prepopulated with the Hardware Management
Console (HMC) ID and is disabled. The Password box accepts any password
for the HMC user ID and essentially sets the password with this first use.
Figure 6-89 Initial password set to Flexible Service Processor
2. After the password is entered, click Request Access.
Figure 6-90 and Figure 6-91 on page 241 show the process steps and the
successful completion of the access requested, as indicated by the OK in the
Access column.
Figure 6-90 Access request in process
Important: Remember this password set for initial access, as it is needed
if access to the node is requested again.