Specifications

27
Using BIOS
Main Features
This option displays basic information about your system.
v 02.58 (C) Copyright 1985-2004, American Megatrends, Inc.
Use [ENTER], [TAB]
or [SHIFT-TAB] to
select a field.
Main Advanced Power Boot Exit
System Time (mm:dd:yy) [00:59:19]
System Date (hh:mm:ss) [Thu 09/08/2005]
Language [English]
Floppy Diskette A: [Not Installed]
f
f
f
f
f
f
f
f
f
f
Installed Memory 512MB/PC2-3200
Memory Bank 1 256MB DDR2 SDRAM
Memory Bank 2 256MB DDR2 SDRAM
BIOS Revision 0.04 09/08/05
Core Version 08.00.12
Use [+] or [-] to
configure system Time.
BIOS CMOS Setup Utility- Copyright (C) 1985-2004, American Megatrends, Inc.
First Channel Device 0 : [Hard Disk]
First Channel Device 1 : [ATAPI CDROM]
Second Channel Device 0 : [Not Detected]
Second Channel Device 1 : [Not Detected]
Third Channel Device 0 : [Not Detected]
Fourth Channel Device 0 : [Not Detected]
Fifth Channel Device 0 : [Not Detected]
Sixth Channel Device 0 : [Not Detected]
ff
ff
fFirst Channel Device 0 (Hard Disk)
Your computer has two IDE channels (Primary and Secondary) and each channel can be
installed with one or two devices (Master and Slave). Use these items to
configure each device on the IDE channel.
Press <Enter> to display the IDE submenu:
System Time and Date
The System Time and Date items show the current date and time on the computer. If
you are running a Windows OS, these items are automatically updated whenever you make
changes to the Windows Date and Time Properties utility.
Language (English)
This item determines the Language version of the BIOS; it supports three languages:
English, French and Spanish.
Floppy Diskette A (Not Installed)
This item defines the characteristics of any diskette drive attached to the system. You
can connect one diskette drive to this motherboard.
First /Second/Third/Fouth/Fifth/Sixth Channel Device 0/1
Leave this item at Auto to enable the system to automatically detect and configure IDE/
SATA devices on the channel. If it fails to find a device, change the value to Manual and
then manually configure the drive by entering the characteristics of the drive in the
items described below. Please note that if you choose IDE Channel 2/3 Master, the item
may change to Extended IDE Drive.
Refer to your drive’s documentation or look on the drive casing if you need to obtain
this information. If no device is installed, change the value to None.
↔
qr
+ -
Select Screen
Selecct Item
Change Field
Tab Select Field
F1 General Help
F5 Load Defaults
F10 Save and Exit
ESC Exit