Owner's Manual

15
System
This window includes all the basic configuration tools such as
options to set up password, re-load the factory default settings,
and view system status.
> Password Setting
This option allows you to use other personal password to re-
place the default password (admin). First, enter the old pass-
word, and then enter the new password twice to confirm the
password changed. Then, click Apply to save the settings.
> Factory Default
You may re-load the factory settings of your Software AP.
> System Status
This option contains detail information of your Software AP,
including general information and respective network settings.
Tip: Once you have
changed the settings in
each option, click Apply
to save the settings, or
Cancel to abandon.
Clicking Help can bring
up the help window.
LAN
LAN is short for Local Area Network. This is considered your
internal network. In the LAN Setting window, you can configure
the IP setting.
> IP Setting
The default setting of the IP address is obtained from your DHCP
server. If there is no DHCP server in your network, uncheck the
Enable DHCP client option and set up the IP address for your
Software AP.
- DHCP Client: When set to Enable, your Software AP can
obtain an IP address automatically from
the DHCP server.
- IP Address: The IP address of the LAN interface.
- Subnet Mask: The subnet mask of the LAN interface.
- Default Gateway: The IP address of the router/gateway
in your network.