Installation Sheet

• Install the second plank in the second row by inserting the short end tongue into the previously installed
plank’s groove. Align the plank so that the long side tongue tip is positioned just over the groove lip of the
plank in the first row (Figure F). Working from the end seam, at a low angle, insert the long tongue into the
groove of the adjoining plank. Very little force is required to fit the tongue into the groove. You should be able
to feel the tongue lock into the groove (Figure G). Continue locking each piece into place, short side first and
then long side.
• To fit the last row, lay a plank on top of the previous row. With the plank against the wall, mark a line down
the length of the plank and cut the planks accordingly (Figure H).
• Door Frames and heating vents also require expansion room. Cut the planks to the correct length. Place the cut
plank next to its actual position, use a ruler to measure the areas to be cut out and mark them. Cut out the
marked points allowing the necessary expansion distance on each side. T-molding is suggested in all
doorways.
• You can trim doorframes by turning a panel upside down to use as a height guide. Using a handsaw, cut door
frames to the necessary height so that planks slide easily under them.
• To finish the perimeter of the room, install quarter round molding using finishing nails. Nail quarter round
directly into the baseboard not the flooring.
Maintenance, Tips, and Warnings
MAINTENANCE:
Dust-mop or broom can be used for daily maintenance. When necessary, clean with a MOIST cloth or mop and
a neutral PH cleaner – heavy use of detergent cleaners will leave a residue and, over time, lead to a cloudy film.
NEVER USE floor polish or floor cleaning wax, oil soaps, etc. These products can damage and/or leave a film
on the flooring. This is not a defect in the floor.
TIPS:
- Always use felt tip protectors on all furniture legs/feet
- Entryway/walk off mats are recommended; Warning: Never use rubber protective mats. - Area rugs are
recommended
- Keep pet nails trimmed
- Sharp shoe-heels (e.g. high-heels) may dent the floors
- Never slide furniture across a floor without pads
- Keep floors clean
WARRANTIES:
Joint Integrity: During the period of the warranty the Unilin locking system will not fail when properly
installed and maintained according to manufacturer’s instructions. Installed flooring must remain climate
controlled with the temperature between 55-95⁰ F (12-53⁰C) for the life of the product, with the above listed
exceptions.