User Manual
Table Of Contents
- Unpacking
- Safety Information
- Quick Start
- Specifications
- Block Diagram
- Rear I/O Panel
- Overview of Components
- CPU Socket
- DIMM Slots
- PCI_E1~6: PCIe Expansion Slots
- M2_1~2: M.2 Slots (Key M)
- SATA1~6: SATA 6Gb/s Connectors
- JLPT1: Parallel Port Connector
- CPU_PWR1, CPU_PWR2, ATX_PWR1: Power Connectors
- JUSB1~2: USB 2.0 Connectors
- JUSB3~4: USB 3.2 Gen1 Connectors
- CPU_FAN1, PUMP_FAN1, SYS_FAN1~4: Fan Connectors
- JAUD1: Front Audio Connector
- JCI1: Chassis Intrusion Connector
- JFP1, JFP2: Front Panel Connectors
- JTPM1: TPM Module Connector
- JCOM1: Serial Port Connector
- JRGB1, JRGB2: RGB LED Connectors
- JBAT1: Clear CMOS (Reset BIOS) Jumper
- CLR_CMOS1: Clear CMOS Button
- BIOS Setup
- Software Description
- RAID Configuration
- Using AMD RAID Controller BIOS Configuration Utility
- Initialize Disks
- Create Arrays
- Delete Arrays
- Swap Arrays
- Manage Spares
- Change the Controller Options
- Booting the system from an array
- Pausing the boot sequence for warning messages
- Change the Staggered Spinup Count
- Using UEFI to create a 2.2TB RAID
- Installing RAID Driver
- Troubleshooting
103
RAID Configuration
Change the Staggered Spinup Count
Depending on a system’s power supply load-rating, you might want to limit the
number of disks that are spun-up together when a system is powered on.
1. At the Controller Options submenu, use the arrow keys to highlight Set Staggered
Spinup Count and press Enter. The number within the brackets changes colour to
indicate it is selected.
2. Use the arrow keys to change the number within the brackets. The minimum is 1
and the maximum is 8.
3. Press Enter to save the setting.