User Manual
Table Of Contents
- Quick Start
- Safety Information
- Specifications
- Package contents
- Block Diagram
- Rear I/O Panel
- Overview of Components
- CPU Socket
- DIMM Slots
- PCI_E1~5: PCIe Expansion Slots
- M2_1~3: M.2 Slots (Key M)
- SATA1~6: SATA 6Gb/s Connectors
- JFP1, JFP2: Front Panel Connectors
- CPU_PWR1~2, ATX_PWR1: Power Connectors
- JBLK_U1: Base clock Plus connector
- V-Check Points Lite
- JSLOW1: Slow Mode Booting Jumper
- JLN1: Low Temperature Booting Jumper
- JOC_RT1: OC Retry Button
- JOC_FS1: OC Force Enter BIOS Button
- JAUD1: Front Audio Connector
- JUSB1: USB 3.2 Gen 2 Type-C Connector
- JUSB2: USB 3.2 Gen 1 Connector
- JUSB3~4: USB 2.0 Connectors
- JTPM1: TPM Module Connector
- CPU_FAN1, PUMP_FAN1, SYS_FAN1~6: Fan Connectors
- JTBT1: Thunderbolt Add-on Card Connector
- JRTD3: Intel RTD3 Connector
- JCI1: Chassis Intrusion Connector
- JBAT1: Clear CMOS (Reset BIOS) Jumper
- POWER1, RESET1: Power Button, Reset Button
- JRGB1: RGB LED connector
- JRAINBOW1~2: Addressable RGB LED connectors
- JCORSAIR1: CORSAIR Connector
- Onboard LEDs
- Installing OS, Drivers & Utilities
- UEFI BIOS
- Nahimic 3
- RAID Configuration
- Intel® Optane™ Memory Configuration
- Troubleshooting
38
Overview of Components
JSLOW1: Slow Mode Booting Jumper
This jumper is used for LN2 cooling solution, that provides the extreme overclocking
conditions, to boot at a stable processor frequency and to prevent the system from
crashing.
JLN1: Low Temperature Booting Jumper
This jumper is used for liquid nitrogen cooling system to boot at an extreme low
temperature. Try to set it Enabled to increase the boot success rate.
Normal
(Default)
Enabled
(Please enable this jumper
during BIOS POST.)
⚠
Important
∙
Users will try extreme low temperature overclocking at their own risks. The
overclocking results will vary according to the CPU version.
∙
Please don’t set to Enabled when power-off or the system will be un-bootable.
Enabled
(Please enable this jumper
during BIOS POST.)
Normal
(Default)
JLN1
JSLOW1