User Manual

67
UEFI BIOS
▶ Intel (R) Thunderbolt sub-menu
Sets the Intel thunderbolt device function. This sub-menu is only available when
using the Intel thunderbolt device.
▶ USB Configuration sub-menu
Sets the onboard USB controller and device function. Press Enter to enter the
sub-menu.
▶ Power Management Setup sub-menu
Sets system Power Management of ErP and AC Power Loss behaviors. You can
optimize the system power consumption in this menu.
▶ Wake Up Event Setup sub-menu
󽙋
▶ Secure Erase+
Enables or disables Secure Erase+ function. Secure Erase+ is the best way to
󽙋
after enabling Secure Erase+.
▶ NVMe SSD Self-Test
Enables or disables the internal check of SSD health, ensure NVMe device is
operating as expected. This function is only supported with NVMe 1.3 compatible
(and above) SSD devices.
▶ Boot sub-menu
Use this menu to set the system boot states and the sequence of system boot devices.
▶ Security sub-menu
Use this menu to set the administrator password and the user password for system
security. This menu also allows you to set the TPM (Trusted Platform Module)
function.
⚠
Important
When selecting the Administrator / User Password items, a password box will appear
on the screen. Type the password then press Enter. The password typed now will
replace any previous set password from CMOS memory. You will be prompted to
confirm the password. You may also press Esc key to abort the selection.
To clear a set password, press Enter when you are prompted to enter a new
password. A message will confirm the password is being disabled. Once the password
is disabled, you can enter the setup and OS without authorization.
▶ Save & Exit
This menu allows you to load the BIOS default values or factory default settings into
the BIOS and exit the BIOS setup utility with or without changes.