Manual

1-14
Gettng Started
Mountng Screw Holes
When nstallng the motherboard, rst nstall the necessary mountng stands requred
for an ATX motherboard on the mountng plate n your computer case. If there s an I/O
back plate that came wth the computer case, please replace t wth the I/O backplate
that came wth the motherboard package. The I/O backplate should snap easly nto
the computer case wthout the need for any screws. Algn the mountng plate’s mount-
ng stands wth the screw holes on the motherboard and secure the motherboard wth
the screws provded wth your computer case. The locatons of the screw holes on the
motherboard are shown below. For more nformaton, please refer to the manual that
came wth the computer case.
Important
Install the motherboard on a at surface free from unnecessary debrs.
To prevent damage to the motherboard, any contact between the motherboard cr
-
cutry and the computer case, except for the mountng stands, s prohbted.
Please make sure there are no loose metal components on the motherboard or wthn
the computer case that may cause a short crcut of the motherboard.
•
•
•
Screw holes
The I/O ports should
be facng toward the
rear of the computer
case. They should
lne up wth the holes
on the I/O backplate.