Instruction Manual

2-6
BIOS Setup
PCIE GEN3
Ths tem s used to enable (Auto)/ dsable (Dsabled) the PCIe generaton 3
support.
PCI Latency Tmer
Controls how long each PCI devce can hold the bus before another takes over.
When set to hgher values, every PCI devce can conduct transactons for a longer
tme and thus mprove the eectve PCI bandwdth.
ACPI Settngs
Press <Enter> to enter the sub-menu.
ACPI Standby State
Speces the power savng mode for ACPI functon
[S1] Sleep Mode. Hardware remans on.
[S3] Suspend to RAM. Turns o hardware. (Recommended)
Power LED
Congures how the system uses power LEDs on the case to ndcate sleep/
suspend state.
[Sngle] The power LED turns o durng the sleep/suspend mode.
[Dual] The power LED changes ts color to ndcate the sleep/suspend
state.
[Blnkng] The power LED blnks to ndcate the sleep/suspend state.
Integrated Perpherals
Press <Enter> to enter the sub-menu.
Onboard LAN Controller
Ths tem allows you to enable/ dsable the onboard LAN controller.
LAN Opton ROM
Ths tem s used to decde whether to nvoke the Boot ROM of the onboard LAN.
Network Stack
Ths tem s used to enable/ dsable UEFI network stack.
Ipv4 PXE Support
Ths tem appears when you set “Enabled” n [Network Stack] eld and s used to
enable/ dsable the Ipv4 PXE boot support.
Ipv6 PXE Support
Ths tem appears when you set “Enabled” n [Network Stack] eld and s used to
enable/ dsable the Ipv6 PXE boot support.
WF Controller
Ths tem allows you to enable/ dsable the WF controller.
Bluetooth Controller
Ths tem allows you to enable/ dsable the Bluetooth controller.
SATA Mode
Ths tem s used to specfy RAID/ IDE/ AHCI mode for SATA port.
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶