Instruction Manual

B-8

Intel RAID

Reset Dsks to Non-RAID

Select opton 3 Reset Dsks to Non-RAID and press <Enter> to delete the RAID

volume and remove any RAID structures from the drves. The followng screen

appears:

DISK / VOLUME INFORMATION

[ ]

4. Recovery Volume Optons

5. Ext

RAID Volumes :

None dened.

Physcal Devces :

Port Devce Model Seral # Sze Type/Status (Vol ID)

1 XXXX-XXXXXXXX XXXXXXXXXXXXXX XXX.XGB Non-RAID Dsk

2 XXXX-XXXXXXXX XXXXXXXXXXXXXX XXX.XGB Non-RAID Dsk

[ ↑↓] - Select [ESC] - Ext [ENTER] - Select Menu

1. Create RAID Volume

2. Delete RAID Volume

Resettng RAID dsk wll remove ts RAID structures

and revert t to a non-RAID dsk.

[ ]

RESET RAID DATA

WARNING : Resettng a dsk causes all data on the dsk to be lost.

(Ths does not apply to Recovery volumes)

Select the dsks that should be reset.

[ ↑↓] - Prevous/ Next [SPACE] - Selects [ENTER] - Selecton Complete

Port Drve Model Seral # Sze Status

1 XXXX-XXXXXXXX XXXXXXXXXXXXXX XXX.XGB Member Dsk

2 XXXX-XXXXXXXX XXXXXXXXXXXXXX XXX.XGB Member Dsk

[ ]

MAIN MENU

Use the <Space> key to select the dsks and press <Enter> key. A conrmaton sen-

tence wll appear below, and then press <Y> key to accept the selecton.

Important

You wll lose all data on the RAID drves and any nternal RAID structures when you

perform ths operaton.

Possble reasons to “Reset Dsks to Non-RAID” could nclude ssues such as ncom

patble RAID conguratons or a faled volume or faled dsk.

■

•