Owner`s manual

Error code

"HEF”,“BB

F”, “FEF” in

the display

Error code

“SPL” &

"SPH" in

the display

Please cut the power supply off to your Mspa, and then plug in again, make sure the right connection of pin

plugs, restart power pack operation. If it still doesn’t work, please contact your country MSpa service center.

Please cut the power supply off to your Mspa, and then plug in again, make sure the right connection of pin

plugs, restart power pack operation.

Please check if there is any water frozen inside the spa and control box, use warm water to melt and get

water temperature higher than zero degree.

Do not use the spa. Please contact your country MSpa service center.

Pin plug connection failure

SPL, temperature lower than

zero degree

SPH, abnormal high

temperature

Warning: Water protection levels of Appliance

at different product zones are different see the

following scheme.

NOTE - The measured zone dimensions are

limited by walls and ﬁ xed partitions.

Figure 702A - Zone dimensions of swimming

pools and paddling pools.

SAFETY & ANNOUNCEMENTS

a. A local supplementary equipotent bonding

shall connect all extraneous conductive parts in

Zones 0,1 and 2 with protective conductors of all

exposed conductive parts situated in these zones.

b. The measures of protection by non-conducting location and by earth-free equipotent bonding are not

permitted.

c. Electrical equipment shall have at least the following degrees of protection:

In Zone 0: IPX8 In Zone 1: IPX5 In Zone 2: IPX4.

d. Junction boxes shall not be installed in Zones 0 and 1 except in zone 1,where permitted for SELV

circuits.

e. In Zones 0 and 1, no switchgear and accessories shall be installed.

f. The transformer must be located outside zone1.

1.5m

Zone 1 Zone 1Zone 2 Zone 2

Zone 0

1.5m 1.5m2.0m2.0m

2.5m

1.5m

WATER PROTECTION LEVEL