Owner`s manual

B. Assembly

Required number of personal for assembly: Spa tub installation requires a licensed electrician and an ordinary installa-

tion individual.

The connecting cable must be above H07RN-F 1.0mm

1) Use a screwdriver to take the terminal box out from the control box, and then open the cover of the terminal box.

2) Connect the wire to the terminal box according to the mark of the lines. Make sure the wires are well fastened.

3) Tighten its water-proof connector, x external power cord, put the cover to the terminal box and fasten it with screws.

4) Put the terminal box back into the control box.

5) Connect external power cord to power supply.

Warning: The above process should be only carried out by licensed electricians.

a) Unfold the Spa pool from the packaging. Take out the spa pool body, cover and temp barrier mat. Make sure spa and

cover top are right side up. Put temp barrier mat(optional) under the spa tub.

Note: B-100 includes a side bar, which needs to be placed before lling water to the tub. The side bar helps

keeping the spa pool in its proper shape after lling.

Temp barrier mat (optional) can prevent heat loss from bottom of the unit and provide better heat preservation with to-

gether of the inatable bladder (optional) being used.

It is possible to install and leave the spa tub outside at a temperature below 4°C, but only if the water temperature inside

the pool is higher than 4°C and water in pipe is not frozen. The spa tub can be operated in cold weather with tempera-

ture down to maximum -10°C if the unit is properly set up and no frozen water inside the control box, pipes or spa pool.

It’s helpful to put temp barrier mat in between the spa pool and the ground. Similar mat which is made of foam material

or other materials with temp barrier function can also be used.

b) To make the control box stands rmly, please use nails to x the control box onto the oor.

Don’t install Mspa onto the lawn as grass may cause air pump damped and rusted

which could result the air pump works improperly and will void your warranty.

c) Screw the control panel onto the spa tub, fasten the ring to the pipe adaptor.

Precautions:

1. When using the spa tub outside, air pipe can not be taken off. Do not use the

spa tub in rains as air pump will not working properly.

2. The two O-ring part on the air pipe is important to get the spa tub working

properly. Lost of the O-rings could cause air pump rusted or not working properly.

Missing of the O-rings also affects bubbling function.

1) 2) 3)

terminal

box

Natural line

Live line

N L

Protection

Earth line

External Equipotential

Bonding

For B-130, B-150 and B-140 only Put the side leather cover on the spa tub.

Attention: make sure the 2 holes on the leather cover t the right

positions of spa tub.

(d)

(c)