Owner's Manual

INSTALLATION
1. Take out the LED strip from the package box, spread it gently.
2. Refer to your MSpa User’s Manual for spa inflation. Assemble the LED strip onto spa bottom after the spa pool is
properly inflated.
3. Put the spa pool up side down. Make sure the installation location must be free of sharp objects or debris. It is
recommended to place a ground mat to protect the spa tub before installation. Connect the LED strip (End point)
to the spa bottom beside the control box, either clockwise or counterclockwise is good.
4. Find the PVC connecting channels on the spa pool bottom to secure the LED strip. Starting from either side of the
control box, take the end point of the LED strip, make it get trough the PVC channel one by one. Ensure the strip
light front side (with the chips) face to the spa pool bottom.
Please note the Power connection end of the LED strip can not be passed through the PVC channel.
To help reduce the friction between the LED strip and PVC channel during assembly or disassembly, please
gently spray the LED strip with some water before install or uninstall the LED strip.
5. During the installation, make sure the LED strip pass through each PVC channel completely and correctly before
to the next PVC channel, no twist or bump. Never pull the strip with excessive force, which will cause damage to
the strip and void the warranty. Place the LED strip on the spa bottom and chips face inside the spa for best
lighting effect.
6. After passing through all the PVC connection channels smoothly, the LED strip makes an even circle at the spa
tub bottom. Now turn the spa tub over and place it on the floor gently. Find the Power connection end of LED strip
bottom, and then connect it to the AC power adapter, plug into the outlet and check if the LED strip operates
normally.
Connect LED strip to the AC adapter
PVC Channel
Front side
of the strip
Choose either side of the
control box to start
connecting the LEDstrip
Front side face to the spa
bottom