Manual
7
115 A
115 B
Standard Beam Clamps Long Beam Clamps for Rails >168”
115: Standing on the North Side of the array with the Tube to Beam bolts started but not ghtened,
sight the beams to ensure they are parallel. If not, twist the array unl they are. .
116 A
116: Plan the layout of your rails according to your module manufacturer’s recommendaon. Install the
Beam Clamps on the I-beam using the 3/8” x 1 1/4” carriage bolts and 3/8” ange nuts. Tighten to 20
lbs. The TOP-15 uses a long angle-shaped clamp to give extra support to the span and canlever. Aach
angle using the square plates provided and the 3/8” x 1 1/4” carriage bolts and 3/8” ange nuts.
For the 8-TOP-8, remember to leave a 9-10” gap in the center to allow for the 8 5/8” (OD) pipe to protrude
through, if you wish to put all the modules on at ground level.
*For standard array conguraons using 60 cell modules (approximately 40” x 65”), see pg 11.
Then ghten all the 3/4” bolts between the Pipe and Rectangular Tubes and the Tubes and the I-Beams
to 100 lbs.
116 B