Manual

A
Pole Mount Side View
Note: Adjuster and Support Pole Omitted for Clarity
NOTE: ONLY ONE SIDE SHOWN.
REPEAT ON OTHER SIDE.
TWO BOLTS TOTAL PER POLE CAP
NOTE: ONLY ONE SIDE SHOWN. REPEAT ON OTHER SIDE. TWO BOLTS TOTAL NOTE: ONLY ONE SIDE SHOWN. REPEAT ON OTHER SIDE. TWO BOLTS TOTAL NOTE: ONLY ONE SIDE SHOWN. REPEAT ON OTHER SIDE. TWO BOLTS TOTAL
POLE CAP
DETAIL A
SCALE 1 : 8
15/32" hole in U-Bracket
High Tilt/High Wind Additional Bolt Detail
SHEET 1 OF 1
3/30/17
TJ
SCALE: 1:16
REV
DWG. NO.
A
SIZE
TITLE:
NAME
DATE
MFG APPR.
ENG APPR.
CHECKED
DRAWN
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF MT SOLAR LLC. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF MT SOLAR LLC IS PROHIBITED.
HIGH WIND ADDENDUM
Instructions: This is the final step in the installation, to be done once array is installed, hoisted into place, and the set bolts are tightened. Use the drill bit provided by MT Solar to drill through the existing 15/32" holes in the U- bracket and through the support pipe on both sides. Thread in the 1/2" x 1" bolt through the pole cap and support pipe.
The bolt-through option may be required if your array meets the following criteria: - TOP-12 or larger, < 45 degree tilt, Exp C - TOP-15 or larger, < 45 degree tilt, Exp B or C *Please contact MT Solar if you need help determining whether or not this is required.