Manual

5
107 A
108
107 B
107: Aach the Screw Adjuster to the tab on the Back Plate with the 1/2” x 1 1/2” Bolt. If using the
Manual Plate Adjuster, aach it with the 1/2” x 1 1/2” Bolt and 1/2” ange nut. Make sure the bolt is
snug ght, but do not over-ghten to allow for some movement of the adjuster tab.
108: Slide the 2” pipe through the screw adjuster and slide the 4.5" pipe through the U Bracket Assembly
sleeve.
109
110 A
109: Center pipes in sleeves. There should be approximately 16” of the 4.5” pipe on either side of the
sleeve.
110: Slide collars on 4.5” pipe and ghten 1/2” x 1” square head set bolts to 45  lbs. Hold collar rm
against the sleeve when ghtening.
16”
16”
110B
Screw
Adjuster
Plate
Adjuster