Installation Guide

13Section 3 — ASSembly & Set-Up
4. Using two ⁄” wrenches, secure the chute assembly to the
chute ring with three flange keepers, six hex screws and
flange nuts as show in Figure 3-18.
Important: Do not over-tighten the flange keeper
hardware. Doing so may result in the chute binding during
rotation.
NOTE: After installing the first flange keeper, rotate the
chute to more easily access the chute ring holes and install
the next flange keeper.
Figure 3-18
5. Secure the flex shaft to the upper chute crank with the hair
pin clip.
See Figure 3-19.
Figure 3-19
Attaching the Lift Handle Assembly
Use Hardware Bag 689-00355 to attach the lift handle assembly.
NOTE: Having an assistant support and position the lift handle
assembly will aid in completing the following step.
1. Using two ⁄” wrenches, secure the lift handle to the auger
housing assembly with three hex screws and flange lock
nuts. See Figure 3-20.
Figure 3-20
2. Position the cable housing in the notch on the lift handle.
Attach the Z-fitting end of the lift cable to the lock rod
found on the lift shaft assembly. See Figure 3-21.
Figure 3-21