Installation Guide

14 Section 3— ASSembly & Set-Up
NOTE: Supporting the end of rail assembly with a 4x4 block of wood
(beneath both rails) will aid in completing the following step.
2. Pivot the rear of the frame rail assembly upward and secure
it to the inside of the carriage assembly with the clevis pins
and hairpin clips removed earlier. See Figure 3-24.
NOTE: Pushing up on the lift handle will assist in pivoting
the rear frame rail assembly into position.
Figure 3-24
3. Squeeze the trigger found near the grip on the lift handle
assembly and lift the handle up to align lift link ferrule and
the hole in the bumper.
4. Remove the hair pin clip from the lift link ferrule. Insert
the lift link ferrule into the hole found on the front right
area of the bumper and secure it with the hairpin clip just
removed. See Figure 3-25.
Figure 3-25
3. Pull the cable outward to take up slack, and tighten the
jam nuts to secure the cable housing to the lift handle. See
Figure 3-22.
Figure 3-22
Mounting the Assembled Components to the Tractor
1. Roll the tractor into position over the frame rail assembly,
aligning the frame rails with the carriage assembly.
See Figure 3-23.
Figure 3-23