Installation Guide

9Section 3 — ASSembly & Set-Up
4. If your tractor is equipped with a Electric PTO, attach the
5” extension spring to the wireform S-hook and then to
the carriage idler bracket as show in Figure 3-6.
Figure 3-6
5. Place the deck lift lever in the notch marked 3.
6. Position the carriage beneath the tractor.
7. Carefully raise the carriage up and position the slots on the
front of the carriage over the pins on the support brackets.
See Figure 3-7.
Figure 3-7
2. Remove the rod from the rear of the carriage assembly.
Retain the clips and rod, as they will be reattached in later
steps. See Figure 3-4.
Figure 3-4
3. If your tractor is equipped with a Manual PTO, attach the
5” extension spring to the carriage idler bracket as show in
Figure 3-5.
Figure 3-5