User guide

ManualsBrandsMTD ManualsGardening equipment105

OWNEirS GUIDE

AMERICAN AMERICAN

MADE OWNED

OUTDOOR POWER EQUIPMENT

Important: Read Safety Rules and Instructions Carefully

20" and 21 "

MULCHING

ROTARY MOWERS

Model Series

105 thru 108

(Push)

130 thru 148

(Self-Propelled)

730 thru 738

(Push)

"•N

WARNING: This unit is equipped with an internal combustion engine and should not be used on or near any

unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped

with a spark arrester meeting applicable local or state laws (if any). If a spark arrester is used, it should be

maintained in effective working order by the operator.

In the State of California the above is required by law (Section 4442 of the California Public Resources Code).

Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is avail

able through your nearest engine authorized service dealer or contact the service department, P.O. Box 368022,

Cleveland, Ohio 44136-9722.

MTD PRODUCTS INC • P.O. BOX 368022 • CLEVELAND, OHIO 44136-9722

PRINTED IN U.S.A. FORM NO. 770-8558J

Summary of content (12 pages)

PAGE 1
OWNEirS GUIDE AMERICAN AMERICAN M O W N E D A D E OUTDOOR POWER EQUIPMENT Important: Read Safety Rules and Instructions Carefully 20" and 21 " MULCHING ROTARY MOWERS Model Series 105 thru 108 (Push) 130 thru 148 (Self-Propelled) 730 thru 738 (Push) "•N WARNING: This unit is equipped with an internal combustion engine and should not be used on or near any unimproved forest-covered, brush-covered or grass-covered land unless the engine’s exhaust system is equipped with a spark arrester meeting a
PAGE 2
IMPORTANT A SAFE OPERATION PRACTICES THIS SYMBOL POINTS OUT IMPORTANT SAFETY lIJSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OF YOURSELF AND )THERS. READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE YOUR LAWN MOWER. FAILURE TO COMPLY WITH THESE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. WHEN YOU SEE THIS SYMBOL— ^ HELD ITS WARNING.
PAGE 3
SET-UP INSTRUCTIONS Remove the hairpin clips from the outer hole in the weld pins on the handle mounting brackets. Place the hairpin clips in the inner hole. IMPORTANT: This unit is shipped WITHOUT GASO LINE or OIL. Be certain to service engine with gaso line and oil as instructed in the separate engine manual before operating your mower. NOTE: Reference to right or left hand mower is observed from the operating position.
PAGE 4
II CONTROLS Blade Control Handle Drive Clutch Control ▲ 1 hrottle Control WARNING: The throttle used to stop the engine. control cannot be RECOIL STARTER The recoil starter handle is attached to the handle. See figure 2. Stand behind the unit in the operating position to start the unit. Recoil Starter DRIVE CLUTCH CONTROL FIGURE 2.—Self-Propelled 6-Speed Model Shown BLADE CONTROL HANDLE WARNING: This controi mechanism safety device. Never attempt to A is a bypass its operations.
PAGE 5
4. BEFORE STARTING ^ 1. Self-Propelled Models Only: Before each use, check for proper drive clutch operation forming the following before starting the engine: by If it does not and the rear wheels tend to lock up, the clutch may not be releasing completely. Do not start the engine until corrections have been made. Check the control cable for severe bend kinks and binding, or grass build-up around the belt. Correct and adjust as required.
PAGE 6
II HANDLE HEIGHT ADJUSTMENT ADJUSTMENTS A WARNING: Do not at any time miike any adjustment to lawn mower withe ut first stopping engine and disconnecting spark piug wire. Your mower is height position. as follows. 1. Remove the starter rope from the rope guide. 2. Remove the upper handle by removing the hand knobs and carriage bolts. Lay the upper handle out of the way, being careful not to bend or kink the cables. 3. Remove the hairpin clips from the weld pins on the handle brackets.
PAGE 7
SIX SPEED SHIFT CABLE ADJUSTMENT (Six Speed Models Only) Periodic adjustment of the six speed shift cable may be required due to normal stretch and wear on the cable. Adjustment is needed if all six speeds cannot be obtained. FIGURE 7. THROTTLE CONTROL ADJUSTMENT If the throttle control requires adjustment or if it has been replaced, adjust the throttle control as follows. 1. Remove the screw shown in figure 8. Remove the cable clamp from the cable.
PAGE 8
1I Engine—Follow engine manual for lubrication instruc tions. Transmission (Self-Propeiled Models Only)—The transmission is pre-lubricated and sealed at the facto ry. It does not require checking. If disassemijled for any reason, fill with 2 ounces of Alvania grease, part number 737-0168. When replacing the blade, be sure to install the blade with the side of the blade marked “Bottom” (or with part number) facing the ground when the mower is in the operating position.
PAGE 9
6. Remove the center bolt which secures the blade to the crankshaft. See figure 12. Remove the blade and blade adapter. 7. A. Single Speed Models: Remove the inside belt cover by removing three self-tapping screws and flat washers. A 3/8” wrench is required. See figure 12A. B. Six Speed Models: Remove the two self-tap ping screws which secure the lower pulley half. See figure 12B. Rotate the lower pulley half 90° clockwise (see figure 13A) and remove from mower. Remove the belt from around the crankshaft.
PAGE 10
II 3. Coat mower’s cutting to prevent rusting. OFF-SEASON STORAGE The following steps mower for storage. should be taken to prepare blade with chassis 4. Store mower in a dry, clean area. Do next to corrosive materials, such as fertilizer. lawn grease not store NOTE: When storing any type of power equipment in an unventiiated or metal storage shed, care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the equipment, especially cables and all moving parts. 1.
PAGE 11
USE THIS PAGE AS A GUIDE TO DETERMINE SLOPES WHERE YOU MAY NOT OPERATE SAFELY. . SIGHT AND HOLD THIS LEVEL WITH A VERTICAL TREE ------------------- A POWER POLE ^-------------- ------------------------ A CORNER OF A BUILDING OR A FENCE POST ......................... ... U4 C9 ........ . ..........4 ^ .......... .. FrTW»fTW»'IHI*ni"^*Trrnr^»
PAGE 12
Copy 4hc iitformci^ioii from your model plofc^ here: \% Have your model number available when you call ODUCTS INC OHIO 44136 Engine Oil (SAE 30) Blade Blade Adapter Kit—Spiined Blade Adapter Kit—Keyed Throttle Cable (B&S) Throttle Cable (Tec.) Brake Cable (B&S) Brake Cable (Tec.