Use and Care Manual

10 Section 3 — ASSembly & Set-Up
3. The rope guide is attached to the right side of the upper
handle. See Figure 3-4. Loosen the wing nut which secures
the rope guide.
a
b
c
d
Figure 3-4
a. Hold blade control against upper handle.
b. Slowly pull starter rope handle out of the engine and
slip starter rope into rope guide. See Figure 3-4.
c. Tighten rope guide wing nut.
d. Insert post on cable tie into hole provided on the
lower handle. Pull cable tie tight and trim excess.
2. Locate the hairpin clip on the pivot stud on each side of
lower handle.
a. Remove hairpin clip from hole at end of stud. See
Figure 3-2.
b
a
Figure 3-2
b. Insert hairpin clip into the hole on pin closest to the
bracket. Repeat on other side.
c. Insert a carriage screw from Group 1 in the hardware
pack into the upper hole on the handle mounting
bracket. Secure with one plastic wing nut from
Group 1. See Figure 3-3. Repeat on other side with
remaining hardware from Group 1.
c
Figure 3-3