User`s manual

6.4.1 Interface Co mmands 113
| www.lakeshore.com
CRVPT Curve Data Point Command
Input CRVPT <curve>,<index>,<units value>,<temp value>[term]
Format nn,nnn,±nnnnnn,+nnnnnn
<curve> Specifies which curve to configure. Valid entries: 21–59.
<index> Specifies the points index in the curve. Valid entries: 1–200.
<units value>Specifies sensor units for this point to six digits.
<temp value>Specifies the corresponding temperature in kelvin for this 
point to six digits.
Remarks Configures a user curve data point.
Example CRVPT 21,2,0.10191,470.000,N[term] sets User Curve 21 second data point to
0.10191 sensor units and 470.000 K.
CRVPT? Curve Data Point Query
Input CRVPT? <curve>,<index>[term]
Format nn,nnn
<curve> Specifies which curve to query: 1–59.
<index> Specifies the points index in the curve: 1–200.
Returned <units value>,<temp value>[term]
Format ±nnnnnn,+nnnnnn (refer to command for description)
Remarks Returns a standard or user curve data point.
DFLT Factory Defaults Command
Input DFLT 99[term]
Remarks Sets all configuration values to factory defaults and resets the instrument. The “99” is
included to prevent accidentally setting the unit to defaults.
DIOCUR Diode Excitation Current Parameter Command
Input DIOCUR <input>,<excitation>[term]
Format a,n
<input> Specifies which input to configure: A or B.
<excitation >Specifies the Diode excitation current: 0 = 10 µA, 1 = 1 mA.
Remarks The 10 µA excitation current is the only calibrated excitation current, and is used in
almost all applications. Therefore the Model 335 will default the 10 µA current set
-
ting any time the input sensor type is changed in order to prevent an accidental
change. If using a current that is not 10 µA, the input sensor type must first be config
-
ured to Diode (INTYPE command). If the sensor type is not set to Diode when the 
DIOCUR command is sent, the command will be ignored.
DIOCUR? Diode Excitation Current Parameter Query
Input DIOCUR? <input>[term]
Format a
<input> A or B
Returned <excitation> [term]
Format n (refer to command for description)