User`s manual

7 . 1 G e n e r a l 127
| www.lakeshore.com
Chapter 7: Options and
Accessories
7.1 General
This chapter provides information on the models, options, and accessories available
for the Model 335 temperature controller.
7.2 Models
The list of Model 335 model numbers is provided as follows:
Model description
Model Description of Models
335 Standard temperature controller. two diode/RTD inputs and two control outputs
Power configurations: the instrument is configured at the factory for customer-
selected power as follows:
Power configurations
1 100 V-US (NEMA 5-15)
2 120 V-US (NEMA 5-15)
3 220 V-EU (CEE 717)
4 240 V-EU (CEE 717)
5 240 V-UK (BS 1363)
6 240 V-Swiss (SEV 1011)
7 220 V-China (GB 1002)
Options
The list of Model 335 options is provided as follows:
Model description
Model Description of Options
3060-H 2-thermocouple input option card. Adds two thermocouple inputs to the Model 335.
7.3 Accessories
Accessories are devices that perform a secondary duty as an aid or refinement to the
primary unit. Refer to the Lake Shore Temperature Measurement and Control Catalog
for details. A list of accessories available for the Model 335 is as follows:
TABLE 7-1
TABLE 7-2
TABLE 7-3
Model Description of Accessories
106-009*† Heater output connector (dual banana jack)
G-106-233*† Sensor input mating connector. (6-pin DIN plug); two included
G-106-735*† Terminal block , 8-pin
MAN-335*† Model 335 user manual.
112-177†
Sensor/heater cable assembly: 10 Feet. Cable as
sembly for two diode/resistor sensors and 
2 heater outputs. Approximately 3 m (10 ft) long. Refer to FIGURE 7-1
.
112-178†
Sensor/heater cable assembly : 20 Feet. Cable assembly for
two diode/resistor sensors and two
heater outputs. Approximately 6 m (20 ft) long. Refer to FIGURE 7-1
.
6201† 1 m (3.3 ft) long IEEE-488 computer interface cable assembly
8001-335
CalCurve™, factory installed: the breakpoint table from a calibr
ated sensor stored 
in the instrument
CAL-335-CERT† Instrument recalibration with certificate
CAL-335-DATA† Instrument recalibration with certificate and data
ES-2-20
Stycast® epoxy 2850-FT, Catalyst 9 (20 packets, 2 g each). S
tycast® is a common, highly versa-
tile, nonconductive epoxy resin system for cryogenic
use. The primary use for Stycast® is for
vacuum feedthroughs or permanent thermal anchors. Stycast® is an alternative to
Apiezon® N Grease when permanent sensor mountings are desired.
TABLE 7-4 Accessories