Programming instructions

1-4
General Information NC Programming 17VRS
DOK-MTC200-NC**PRO*V17-ANW1-EN-P
NC Program Package
1
2
3
4
5
6
NC Program 1
NC Program 99
.
.
Setup List (Optional)
Data for
Process 0
Fig. 1-2: NC program package
The tool setup list contains a tool data set for each T number used in the
NC-program. This tool data set defines which tool is to be used and which
specifications this tool must meet. If the machine tool builder determines
that a setup list is not required, the T number together with its corre-
sponding data set is used in the tool list. The setup list should be entered
before creating the program, however no later than during creation of the
program. Additional information on the setup list is provided in the manu-
als on "
Tool Management
" and "
Tool Data Management
."
The CNC provides up to 60 zero points (10 *(G54..G59)) for each pro-
cess. The zero points are assigned to the currently active 'A' or 'B'
NC-program memory in the CNC-memory. Entries in the zero point table
on the operator interface are always assigned to the currently active
NC-program memory.
Tool setup list