Programming instructions

11-10
Special NC Functions NC Programming 17VRS
DOK-MTC200-NC**PRO*V17-ANW1-EN-P
Group name Group information Sym-
bol
Written by Type Bit Val. Comment
Present Tool not present/
tool present
! WZM EL 1 1
0
Tool not present
Tool not required/
tool required
? WZM EL 2 1
0
Tool not required for process
Error
correction type
Override type error/
no override type error
t WZM EL 3 1
0
Override type does not meet
requirements
Error
number of
edges
Number of edges error/
Number of edges OK
e WZM EL 4 1
0
Edge number does not meet
requirements
Edge error Edge(s) error/
edge(s) OK
f WZM EL 5 1
0
Edge data does not meet
requirements
Reserved for future enhancements (bits 6 - 8)
Location
locking
Location locked/
location not locked
B
ANP/BED
WZM
PL 9 1
0
UP/OP: For example: location
damaged
WZM: Tool is entered
Upper half pocket for flc tool
locked/not locked
WZM PL 10 1
0
Locked for flc tool located in
gripper or spindle
Lower half pocket for flc tool
locked/not locked
WZM PL 11 1
0
Locked for flc tool located in
gripper or spindle
Location
reservation
Upper half pocket
reserved/not reserved
ANP PL 12 1
0
For example: for a tool which is
to be merged into the process
Lower half pocket
reserved/not reserved
ANP PL 13 1
0
For example: for a tool which is
to be merged into the process
Location in use Upper half pocket is
covered/not covered
WZM PL 14 1
0
The upper half pocket is
covered by a tool.
Lower half pocket is
covered/not covered
WZM PL 15 1
0
The upper half pocket is
covered by a tool.
Pocket in use/not in use WZM PL 16 1
0
A tool is located in the pocket
Wear condition Tool dull/tool not dull d WZM WZ 17 1
0
Tool cannot be used any
longer (replace)
Warning limit reached/
warning limit not reached
w WZM WZ 18 1
0
Tool life almost over (replace)
Spare ID Machining tool/
not machining tool
p WZM WZ 19 1
0
There is a primary (machining)
tool for each spare tool group.
Replacement tool/
no replacement tool
s WZM WZ 20 1
0
A spare tool is a tool which is
still usable, not a primary tool
Fixed-location
coding (flc)
Fixed-location tool
non-fixed-location tool
C
ANP/BED
WZ 21 1
0
The tool always stays in the
same pocket in the magazine.
Tool status Tool locked/
tool not locked
L
ANP/BED
WZ 22 1
0
By user or user program,
for example: edge broken
Reserved for future enhancements (bits 23–24)
User Tool
Status 1
User Tool Status Bit 1 any
ANP/BED
WZ 25 1
0
Any desired meaning
.
.
.
User Tool
Status 8
User Tool Status Bit 8 any
ANP/BED
WZ 32 1
0
Any desired meaning
WZM: = Tool management
ANP: = User-specific programs on PLC or CNC
BED: = Operator
EL: = Setup list-specific status bit
PL: = Location-specific status bit
WZ: = Tool-specific status bit
Tool Status Bits for the TLD Command:
Abbreviations: