Programming instructions

NC Programming 17VRS NC Compiler Functions
12-13
DOK-MTC200-NC**PRO*V17-ANW1-EN-P
•
WINDOW_01 (..., ..., . . .) ;Define window size for turning
•
WINDOW_02 (..., ..., . . .) ;Define window size for milling
•
CONT (..., ..., . . .) ;Definition of the initial part contour or of
the final part contour
:
:
END_CONT
•
FORM_20 (..., ..., . . .) ;recess - turning
•
FORM_50 (..., ..., . . .) ;straight elongated hole - milling
•
FORM_51 (..., ..., . . .) ;round elongated hole - milling
•
FORM_52 (..., ..., . . .) ;circle - milling
•
FORM_53 (..., ..., . . .) ;polygon - milling
•
FORM_54 (..., ..., . . .) ;straight text - milling
•
FORM_55 (..., ..., . . .) ;round text - milling
•
FORM_56 (..., ..., . . .) ;rectangle - milling
•
FORM_57 (..., ..., . . .) ;rectangle centered - milling
•
CYCLE_10 (..., ..., . . .) ;contour cut - turning
•
CYCLE_11 (..., ..., . . .) ;roughing - turning
•
CYCLE_12 (..., ..., . . .) ;residual cut - turning
•
CYCLE_40 (..., ..., . . .) ;contour cut - milling
CAUTION
The data items
•
tool edge orientation,
•
tool radius,
•
corner angle, and
•
setting angle
that had been assumed when the machining program
was created must exist when machining is performed.
Please refer to the NC Compiler description in Folder 5 for detailed infor-
mation about these NC compiler functions.
Detailed description