Programming instructions

NC Programming 17VRS Index
15-1
DOK-MTC200-NC**PRO*V17-ANW1-EN-P
15 Index
A
ABS .................................................................................................................10-8
Absolute value function ....................................................................................10-8
ACC .................................................................................................................4-13
ACC_EFF........................................................................................................12-11
Access to current data - ACD_COMP[...] .......................................................12-11
Access to current data in the controller ..........................................................12-11
ACD_COMP ...................................................................................................12-11
ACOS .............................................................................................................10-10
ACOS function................................................................................................10-10
Activating and Canceling Tool Path Compensation .........................................5-33
Constant feed on tool center line 'G98'..........................................................5-37
Insert contour transition arc 'G43'..................................................................5-36
Inserting contour transition chamfer 'G44' .....................................................5-36
Tool path compensation, left of workpiece contour 'G41' ..............................5-34
Tool Path Compensation, Right of Workpiece Contour 'G42'........................5-34
Address letter .....................................................................................................3-2
ACC ...............................................................................................................10-2
D .................................................................................................................10-4
E ...................................................................................................................8-2
F .................................................................................................................10-2
G .................................................................................................................10-4
I, J, K .............................................................................................................10-2
M ..........................................................................................................6-1, 10-5
O .................................................................................................................10-4
P .................................................................................................................10-2
Q ...................................................................................................................6-4
R .................................................................................................................10-2
RX, RY, RZ ....................................................................................................10-2
S ...................................................................................................................6-3
S, S[1..3]........................................................................................................10-2
T ......................................................................................... 5-5, 5-13, 8-1, 10-2
X, Y, Z, A, B, C, U, V, W................................................................................10-2
ADTRC command ..........................................................................................12-10
Angle unit for trigonometric functions ‘RAD’, ‘DEG’..........................................10-6
AP command......................................................................................................9-3
Approach distance for tool radius compensation - ADTRC............................12-10
APR Sercos parameters...................................................................................11-1
Digital drive data read/write ‘AXD’ .................................................................11-1
Data address ..............................................................................................11-1
Data block number......................................................................................11-1
Group letter.................................................................................................11-1
Parameter set number................................................................................11-1
SERCOS ident number...............................................................................11-1
Electronic axis coupling and table interpolators ............................................11-4
Activating transformation in the reference program....................................11-5
De-activating transformation.......................................................................11-5