Programming instructions

NC Programming 17VRS Index
15-3
DOK-MTC200-NC**PRO*V17-ANW1-EN-P
BTE command..................................................................................................9-15
C
Cartesian coordinate system.....................................................................3-1, 3-15
CEV ...................................................................................................................7-7
CF command....................................................................................................12-2
Chamfers..........................................................................................................12-1
Chamfers and roundings ..................................................................................12-1
Contiguous motion blocks .............................................................................12-2
Illegal commands...........................................................................................12-3
No variables...................................................................................................12-3
Change in direction of tool path compensation ................................................5-33
Changing the efficient resulting path acceleration - ACC_EFF.......................12-11
Circular Interpolation 'G02' / 'G03' ...............................
See
Interpolation Functions
Circular interpolation in the clockwise direction G02........................................4-16
Circular interpolation in the counter-clockwise direction G03...........................4-16
Comment in the source program........................................................
See
NC word
Conditional branches........................................................................................9-14
Branch if NC event reset ‘BER’......................................................................9-15
Branch if NC event set ‘BES’.........................................................................9-15
Branch if reference ‘BRF’...............................................................................9-15
Branch if spindle is empty ‘BSE’....................................................................9-14
Branch if tool T0 selected ‘BTE’.....................................................................9-15
Conditional branches upon the results of arithmetic operations.......................9-16
Branch if equal to zero ‘BEQ’.........................................................................9-16
Branch if greater than or equal to zero (if minus) ‘BPL’.................................9-16
Branch if less than zero (if minus)‘BMI’ .........................................................9-16
Branch if not equal to zero ‘BNE’...................................................................9-16
Constant feed on tool center line 'G98'
...................................
See
Activating and canceling tool path compensation
Constant surface speed 'G96' ...................................................
See
Spindle speed
Controller software .............................................................................................1-1
Coordinate system..............................................................................................3-1
Coordinate transformation................................................................................4-51
De-selection of coordinate transformation G30 .............................................4-56
De-selection of face coordinate transformation G31 ..................................4-56
De-selection of the lateral cylinder surface
coordinate transformation G32 ................................................................4-56
Face machining .............................................................................................4-51
Lateral cylinder surface machining................................................................4-51
Select Main Spindle for Transformation G Codes 'SPC'................................4-56
Selection of Face Machining ‘G31’ ................................................................4-51
Selection of lateral cylinder surface machining G32......................................4-54
Coordinate value ................................................................................................3-2
COS .................................................................................................................10-9
D
D corrections .............................................................................................1-3, 5-40
Using D corrections .......................................................................................5-41
Data structure used with tool data......................................................................5-1
DCD command...............................................................................................11-13