Programming instructions

NC Programming 17VRS Index
15-7
DOK-MTC200-NC**PRO*V17-ANW1-EN-P
Acceleration 'ACC'.........................................................................................4-13
Block Transition with Lag Present 'G62' ........................................................4-12
Contouring Mode (Acceleration) 'G08'.............................................................4-7
Contouring Mode (Deceleration) 'G09'.............................................................4-9
Exact Stop Before NC-block Transition (with Lag Finishing) 'G61'................4-10
Interpolation with following error 'G07'.............................................................4-5
Minimized Following-Error Mode 'G06' ............................................................4-2
Interpolation Functions .....................................................................................4-14
Circular Interpolation 'G02' / 'G03' .................................................................4-16
Circle radius programming..........................................................................4-20
Defining the arc ....................................................................................4-20
Circle radius programming in the Z-X plane ...............................................4-21
Interpolation parameters I, J, K...................................................................4-17
Full circle in the X-Y plane with G90.....................................................4-18
Full circle in the X-Y plane with G91.....................................................4-19
Helical interpolation .......................................................................................4-22
Helical interpolation in the X-Y plane with G90..............................................4-22
Helical interpolation in the X-Y plane with G91..............................................4-23
Linear Interpolation, Feedrate 'G01' ..............................................................4-15
in 2 axes .....................................................................................................4-15
in 3 axes .....................................................................................................4-16
Linear Interpolation, Rapid Traverse 'G00' ....................................................4-14
Rigid tapping 'G63' / 'G64' .............................................................................4-30
Sequences of thread-cutting blocks using 'G33'............................................4-28
Floating tapping G65 .....................................................................................4-33
Tapping 'G63' / 'G64'......................................................................................4-31
Tapping with G63 and G64.........................................................................4-32
Tapping with ‘G63’ ......................................................................................4-31
Thread cutting 'G33'.......................................................................................4-24
Face thread.................................................................................................4-27
Longitudinal thread .....................................................................................4-25
Longitudinal threads ...................................................................................4-24
Taper thread ...............................................................................................4-26
J
JEV ...................................................................................................................7-6
JMP command....................................................................................................9-9
JSR command..................................................................................................9-10
L
LA_OFF ............................................................................................................12-9
LA_ON..............................................................................................................12-9
LD function .....................................................................................................10-10
Length overrides L1, L2, L3..............................................................................5-21
LG function .....................................................................................................10-10
Linear and rotary auxiliary axes................................................................
See
Axes
Linear Interpolation, Feedrate 'G01' ............................
See
Interpolation Functions
Linear Interpolation, Rapid Traverse 'G00' ..................
See
Interpolation Functions
Linear Main Axes................................................................................................4-1
LN function .....................................................................................................10-10