Programming instructions

NC Programming 17VRS Index
15-13
DOK-MTC200-NC**PRO*V17-ANW1-EN-P
RTS command..................................................................................................9-11
RX .................................................................................................................4-47
RY .................................................................................................................4-47
RZ .................................................................................................................4-47
S
S word ................................................................................................................6-4
S word as auxiliary function................................................................................6-4
Scaling 'G78' / 'G79'..........................................................................................3-24
SE ...................................................................................................................7-1
Select main spindle for feed programming 'SPF'.......................
See
Spindle speed
Sequences of thread-cutting blocks using 'G33'...........
See
Interpolation functions
Set NC event ‘SE’...............................................................................................7-1
Setup lists...........................................................................................................5-3
Data of the setup list........................................................................................5-3
Comment ......................................................................................................5-7
Correction type .............................................................................................5-5
Edge ID.........................................................................................................5-7
Edge orientation .....................................................................................5-7
Geometry limits.............................................................................................5-9
Maximum and minimum lengths ...................................................................5-9
Maximum and minimum radius.....................................................................5-9
Number of edges ..........................................................................................5-7
Time unit.......................................................................................................5-7
Tool identification..........................................................................................5-5
Tool life data .................................................................................................5-9
Maximum tool life....................................................................................5-9
Tool life time ...........................................................................................5-9
Tool name (ID)..............................................................................................5-5
Tool number..................................................................................................5-5
Unit of length.................................................................................................5-7
Units..............................................................................................................5-7
User data ......................................................................................................5-7
Wear factors .................................................................................................5-9
Radius wear factors ( R )......................................................................5-10
Purpose ...........................................................................................................5-3
SIN .................................................................................................................10-9
Skippable blocks ......................................................
See
Elements of an NC block
SP command......................................................................................................9-2
SPC <Spindle number>....................................................................................4-56
Specify tool radius - TL_RADIUS ...................................................................12-10
SPF <spindle number>......................................................................................4-43
Spindle control commands M003, M004, M005, M013, M014............................6-2
Spindle RPM.....................................................................................................4-42
Spindle Speed ..................................................................................................4-42
Constant surface speed 'G96'........................................................................4-45
Select main spindle for feed programming ‘SPF'...........................................4-43
Spindle speed in RPM 'G97' ..........................................................................4-47
S-Word for the Spindle RPM Statement........................................................4-42
Upper spindle speed limit 'G92' .....................................................................4-47