Programming instructions

15-14
Index NC Programming 17VRS
DOK-MTC200-NC**PRO*V17-ANW1-EN-P
Spindle speed in RPM 'G97'......................................................
See
Spindle speed
Spindle stops at end of motion G63 .................................................................4-30
SPT <spindle number>.......................................................................................8-2
SQRT................................................................................................................10-9
Starting point and end point coordinates for the X axis....................................4-27
Subroutines ........................................................................................................9-9
Branch to NC subroutine ‘BSR’ .....................................................................9-11
Jump to NC subroutine ‘JSR’.........................................................................9-10
Return from NC subroutine ‘RTS’..................................................................9-11
Subroutine nesting.........................................................................................9-10
Subroutine Organization................................................................................9-10
Subroutine technique.......................................................................................9-9
S-Word for the Spindle RPM Statement....................................
See
Spindle speed
System parameters ............................................................................................1-3
T
TAN .................................................................................................................10-9
TAN function.....................................................................................................10-9
TCH ...................................................................................................................8-8
Thread cutting 'G33' ....................................................
See
Interpolation functions
TIME...............................................................................................................10-10
Time-based dwell 'G04' ...........................................................................
See
Feed
TL_RADIUS command ...................................................................................12-10
TLD command...............................................................................5-39, 11-8, 11-17
TMS ...................................................................................................................8-8
Tool Change Commands....................................................................................8-8
Branch if tool T0 selected ‘BTE’.......................................................................8-9
Branch with spindle empty ‘BSE’....................................................................8-9
Change tool from magazine to spindle ‘TMS’..................................................8-8
Change Tool from Spindle to Magazine ‘TSM’ ................................................8-9
Complete tool change ‘TCH’............................................................................8-8
Tool Corrections .................................................................................................5-1
Tool length compensation ................................................................................5-38
Tool length compensation active......................................................................5-38
Tool length compensation inactive ...................................................................5-38
Tool length correction.......................................................................................5-39
Tool length correction, cancel 'G47'...............................................................5-39
Tool length correction, negative 'G49' ...........................................................5-39
Tool length correction, positive 'G48'.............................................................5-39
Tool list ...............................................................................................................1-3
Tool lists ...........................................................................................................5-11
Data in the tool list.........................................................................................5-11
Edge ID.......................................................................................................5-17
Edge orientation ...................................................................................5-17
Edge status...........................................................................................5-19
Geometry data ............................................................................................5-20
geometry registers................................................................................5-20
Length corrections (L1, L2, L3).............................................................5-21
offset registers......................................................................................5-20
Radius correction (R)............................................................................5-21