Programming instructions

NC Programming 17VRS Index
15-17
DOK-MTC200-NC**PRO*V17-ANW1-EN-P
Z
Zero offsets.........................................................................................................3-6
Adjustable General Offset in the Zero Offset Table.......................................3-14
Adjustable Zero Offsets 'G54 ... G59' ..............................................................3-8
Cancel Zero Offsets 'G53'..............................................................................3-14
Coordinate Plane Rotation by Angle of Rotation 'P' ........................................3-9
Programmable Absolute Zero Offset ‘G50’....................................................3-12
Programmed incremental zero offset 'G51' ...................................................3-12
Programmed Workpiece Zero Point 'G52'.....................................................3-13
Reading and Writing Zero Offset Data from the NC Program via OTD .........3-14
Zero Offset Tables 'O'....................................................................................3-10
Zero points...................................................................................................1-4, 3-5
Machine reference point ..................................................................................3-5
Machine zero point ..........................................................................................3-5
Workpiece zero point.......................................................................................3-5