Programming instructions

NC Programming 17VRS Motion Commands, Dimension Inputs
3-7
DOK-MTC200-NC**PRO*V17-ANW1-EN-P
piece zero point G52. This allows an identical NC-program to be proc-
essed at various machine positions.
The position of the machine zero point of each axis is declared in the
drive parameters as the difference relative to the reference point. The
value entered in the drive parameters corresponds to the coordinate value
of the reference point in the machine coordinate system.
G52
O8
O9
O0
O1
O2
G54
O8
O9
O0
O1
O2
G59
Adjustable Zero Offsets
Enter and Chan
g
e via User
G54
to
G59
Total Zero Offset to Machine Zero Point
G53
G50
G51
W
Cancel Zero
Points
Pro
g
rammable
Work
p
iece Zero
Point
Set Via the NC Program
Adjustable General Offset in
the Zero Point Table
Enter Via User Interface
Programmable
Incremental Zero Offset
Programmable Absolute
Zero Offset
Set via the NC Program
Cancel by Selecting a New
Zero Offset or by G53
Set via the NC Program
Cancel by Selecting a New
Zero Offset or by G53
Fig. 3-7: Total of zero offsets
The total value of the zero offsets are comprised of:
the
adjustable zero offsets G54 … G59
or the
programmable workpiece
zero point G52
and the
programmable zero offsets G50, G51
as well as
the adjustable general offset in the zero offset table.