Programming instructions

4-4
Motion Blocks NC Programming 17VRS
DOK-MTC200-NC**PRO*V17-ANW1-EN-P
Machining Speed = F8000 Gain Factor = 7
G06, G08
Position Deviation
Circle Section
Evaluation in Quadrant Transition
Oscilloscope Function
Position Value Axis Y
Following error:
Position Command Value:
Expansion Factor: 1693.7
Position Values X Axis
Fig. 4-3: Circular interpolation with Minimized Following-Error Mode, partial view
The next figure shows, by way of comparison, the same circle at a path
feedrate of F1000 mm/min.
Machining Speed =
F1000 , Gain Factor = 7
G06, G08
Circle Diameter 160 mm
Expansion Factor:
Oscilloscope Function
Position Values X Axis [mm]
Position Values Y Axis [mm]
Following error:
Position Command Value:
Axis Number: 1
Axis Type: Dig. Linear Axis
Axis Name: X
Process: Master
Axis Number: 2
Axis Type: Dig. Linear Axis
Axis Name: Y
Process: Master
Fig. 4-4: Circular interpolation with F1000 mm/min and Minimized Following-Error
Mode
The figure below shows an evaluation of the position deviation in the
quadrant transition.