Operator`s manual

9
• Insert the curved end of chute tube into the hole in
the grass bag cover following Figure 8.
• Insert the lower end of the chute tube over the
discharge chute so that its two notches fit into the
two corresponding notches on the discharge chute.
Figure 8
• Secure by placing the ends of the two short retainer
straps on the discharge chute over the pins on the
chute tube. See Figure 9.
Figure 9
SECTION 4: OPERATION
Your triple bagger kit is a valuable accessory to your
tractor. Optimize its performance by operating
correctly. Do not try to fit it on to tractors other than
those specified on page 5.
• Open the grass bag cover by lifting the cover up.
Do not remove the chute tube assembly from the
tractor.
• Remove the grass bags by lifting up and moving
the bags away from the support tube assembly.
• To empty the grass clippings at a proper disposal
sight, use the handle at the bottom of each grass
bag. Holding the bag firmly, empty the contents.
• Under normal usage, the grass bags are subject
to wear and tear. Check these bags periodically
and wash with water if dirty. Allow to air-dry; do
not apply heat.
Insert chute tube here
Place short
strap here
Place long
strap here
Discharge
Chute