Operator`s manual

Lower Chute Crank

Support Bracket Adjustment

If the spiral at the base of the lower chute crank isn’t

fully engaging with the notches in the lower chute

assembly, the support bracket can be adjusted inward

or outward as follows:

1. Loosen, but do NOT remove the two hex nuts

which secure the support bracket to the snow

thrower housing. See Figure 22.

2. Adjust the support bracket inward or outward so

that the spiral is fully engaged in the notches on the

chute before retightening the hex nuts.

Figure 22

SECTION 8: LUBRICATION

Auger Shaft

• At least once a season, remove the shear bolts on

the auger shaft. Oil or spray lubricant inside and on

the plastic bearings on the shaft and near the holes

where the shear bolts were removed before

reattaching them. See Figure 23.

Figure 23

Chute Directional Control

• The spiral on the end of the lower chute crank, the

base of the discharge chute itself and the joint

blocks which connect the lower and upper chute

cranks should be lubed with multi-purpose

automotive grease once a season. See Figure 24.

Figure 24

Hex Nuts

Support Bracket

Spiral

Plastic Bearings

Shear Bolts

Lube Spiral

and Chute Base

Joint Block